Connecting To An Hdtv With An Hdmi Connector - Cisco RNG200 User Manual

Connecting to an HDTV with an HDMI Connector

WARNING:
Electric shock hazard! Unplug all electronic devices before connecting or disconnecting
any device cables to the set-top.
Required cables:
•
1 HDMI cable
RNG200N
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO
RECEIVE OVER-THE-AIR BROADCAST
SIGNALS. CONNECTION OF THIS DEVICE
IN ANY OTHER FASHION MAY CAUSE
HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS AND IS IN VIOLATION
OF THE FCC RULES, PART 15.
CATV CONVERTER
MADE IN MEXICO
Cable
Input
Important Notes Regarding the HDMI Interface on the Set-Top
The HDMI interface automatically confi gures the audio output for a format supported by the television. Because not all
TVs support the Dolby Digital input, the HDMI interface may automatically select a 2-channel stereo audio confi guration
instead of Dolby Digital, which it carries over to the other digital audio outputs of the set-top. This prevents your home
theater system or Dolby Digital decoder from providing the full Dolby Digital surround-sound effect.
You can override this confi guration by completing the following steps.
1. Press SETTINGS twice on the remote control to open the General Settings menu.
2. Press MOVE UP or MOVE DOWN to select the option Audio: Digital Out.
3. Press MOVE RIGHT to select Dolby Digital. (On some models, after you press MOVE RIGHT, you must press
MOVE UP or MOVE DOWN to select Dolby Digital from the list.) This setting will send Dolby Digital audio to the
HDMI, DIGITAL AUDIO OUT, and OPTICAL AUDIO OUT connectors on the set-top.
Notes:
•
If the TV is not Dolby Digital capable, it may not produce audio through its speakers when the Audio: Digital Out
setting on the set-top is set to Dolby Digital. You can either switch the Audio: Digital Out setting back to HDMI when
you are not using the home theater or Dolby Digital decoder, or you can connect the baseband audio outputs (OUT
1 Audio Left and Right) to the TV.
•
Digital content is encrypted with High-Bandwidth Content Protection (HDCP) on the DVI/HDMI port. This set-top
is not compatible with devices that do not support HDCP. You must use either the YPbPr or 1394 connection to
connect the set-top to these devices.
12
OUTPUT
DIGITAL
VIDEO Y
AUDIO
L Pb
R Pr
CABLE IN CABLE IN
Back of HDTV
S-VIDEO
Y
VIDEO
P
B
L/
MONO
AUDIO
P
R
R
HD 1
IN IN
OPTICAL
AUDIO
OUT
MCARD SN: PXCPRPSLV
IR
L
MCARD MAC: 00 1BD73E17D9
CABLE OUT
R
USB 2.0 eSATA
S-VIDEO
OUT
AUDIO
HDMI
CENTER
CHANNEL IN
ON OFF
AUDIO IN
DVI/HDCP
R L
ANT (75 )
VIDEO
Y
L/ ANT-1
L P L
MONO B
AUDIO AUDIO
R
P
R
OUT
R R
HD 2
ANT-2
OUT IN
MULTI-STREAM CAUTION
CABLE CARD
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR
120 VAC
60Hz 4.2A
500W
120VAC C
60Hz 80W
1394 ETHERNET
LISTED 36MW
VIDEO PRODUCT
T13985