Table of Contents
Advertisement
Real-time transmission (non memory transmission)
Your machine will simply dial the other fax and when it makes contact, your machine
will feed the document through, scanning and transmitting real time
• With real time transmission, you can watch each page as it is scanned and sent.
To perform a real time transmission:
1
Switch to the Fax mode by pressing [COPY
2
Place the document on the ADF.
3
Obtain a dial tone, either by:
• Pressing the "Monitor" soft key
–or–
• Lift the handset if you have connected an external telephone to your machine.
In either case, the machine shows:
**
_
– or –
• Press [Advanced Functions] repeatedly until "Memory Tx" appears and press
[Enter]. Then select "Off" and press [Enter] to turn off the memory transmission.
– or –
• If you assigned "Memory Tx" to a soft key (page 8-2), turn off the memory trans-
mission by simply pressing that key.
4
Dial the fax number.
• Use the numeric keys to dial the number.
–or–
• Press a one-touch key. (See page 3-6.)
–or–
• Press [Speed Dial /Group] and three-digit code. (See page 3-8.)
–or–
• Use the phone directory dialing. (See page 3-11.)
NOTE: With real time transmission, only one destination can be dialed.
5
When you hear fax tones from the remote unit, press [Start].
If a person answers the phone, use the handset to tell that person that you are trying
to send a fax. When you hear fax tones, press [Start].
If the call fails and you used "Monitor" to dial, press the "Monitor" soft key to hang up.
If you are using the handset, hang up after pressing [Start].
NOTE: To cancel the transmission, use Review commands features. (See page 4-7)
Tel Mode
**
FAX
SCAN].
4
4
s
endInG faxes
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
4-5
Advertisement
Table of Contents
