Tuning In To A Preset Station - JVC KD-LX333 Instructions Manual

Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (in this example,
FM1).
1 Press SOURCE ATT to
ATT
SOURCE
2 Press and hold BAND
BAND
MODE
M
2
Tune in to a station (in this example,
of 88.3 MHz).
Press
stations of higher frequencies.
Press 4
stations of lower frequencies.
DIRECTORY
FILEDISC
TRACK
CD
3
Press and hold the number button
(in this example, 1) for more than 2
seconds.
EQ
1 7
DIRECTORY
FILEDISC
TRACK
CD
"PI" flashes for a few seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
select FM as the source.
MODE (M) repeatedly to
select the FM1 band.
¢ to tune in to
to tune in to
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on pages 10 and 11.
1
Select the band.
1 Press SOURCE ATT to
ATT
SOURCE
2 If necessary, press and
BAND
MODE
M
Each time you press and hold the button,
the FM band changes as follows:
FM1
2
Select the number (1 – 6) for the
preset station you want.
EQ MONO
8 9
1 7 2 3
When using this unit in an area other than
North or South America:
You need to change the AM/FM channel
intervals. See "To change the AM/FM
channel intervals — AREA" on page 21.
select FM or AM as the
source.
hold BAND MODE (M) to
select the FM band
number (FM1, FM2 or
FM3).
FM2 FM3
INT RPT RND
11 12
10 5 6
11