Table of Contents
Advertisement
6. Note polarity of battery. Note which color wire is on which terminal.
7. Disconnect the wires from the battery and set the battery aside.
8. Connect the replacement battery, making sure the correct color wires are on
the new battery terminals. Make sure POS (+) is red and NEG (-) is black.
CAUTION:
9. Replace the six Phillips screws (do not over tighten) to fasten the two halves
of the light together. Make sure wires are not crushed.
10. Replace rubber end cap so the recharge port is accessible. Charge the
recommended time for a new battery. This is typically 12-24 hours with AC
charging adapter or until the charging indicator LED is lit.
5.3 DC PLUG FUSE REPLACEMENT
The fuse in the DC plug protects the charging circuit of the DC recharge
adapter. If the AC recharger operates but the DC charging adapter does not,
then the fuse may be opened. To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate replacement fuse with same type and rating.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight-DO NOT OVER-TIGHTEN
7. Check for proper operation of DC charger adapter.
5.4 SAFE BATTERY DISPOSAL
Contains maintenance-free, sealed, non-spillable, lead acid battery, which must
be disposed of properly. Recycling is required, contact your local authority for
information. Failure to comply with local, state and federal regulations can result
in fines, or imprisonment.
5.5 BATTERY DISPOSAL WARNINGS:
• Do not dispose of a battery in fire as this may result in an
explosion.
• Before disposing of the battery, protect exposed terminals with
heavy duty electrical tape to prevent shorting (shorting can result
in injury or fire).
• Do not expose batteries to fire or intense heat as they may
explode.
• For more information on recycling these batteries, call toll-free
(877) 288-7722.
7. SPECIFICATIONS
Spotlight Bulb . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 volt, 3H series
Battery . . . . . . . . . . . . Maintenance free,sealed lead-acid, 12 volt ,3amp hour
AC Charger . . . . . . . . . . . . . . . . . . . . UL listed class 2, 12 volt Dc at 300mA
Incorrectly connected wires will not allow the spotlight to operate
properly. Incorrect battery polarity will damage the circuits inside
the spotlight. Double check battery polarity before reassembly!
7
Advertisement
Table of Contents
