Table of Contents
Advertisement
3.1 CHARGING FROM A 12 VOLT DC SOURCE
1. Make sure the DC source (jump starter, battery pack, vehicle accessory socket, etc.)
is 12 volt DC.
2. Plug the DC fused recharge/power adapter (included) into the recharge port locat-
ed in front of the trigger switch, and then insert the power plug into the accessory
outlet of your vehicle or other 12 volt DC power source.
3. Make sure the spotlight is off and the trigger switch is in the OFF position. Allow
approximately 4-6 hours charging time. Recharge until the charging indicator LED
located at the top of the unit, flashes.
3.2 CHARGING FROM AN AC 120 VOLT SOURCE
1. Make sure the AC outlet provides 110 to 120 volt AC at 60 Hz.
2. Recharging from an AC outlet requires the use of the AC/DC recharge adapter
(Figure 2A). Plug the AC outlet (included) into the recharge port located in front of
the trigger switch, and then insert the power plug into a 120 volt AC household
outlet.
3. Make sure the spotlight is off and the trigger switch is in the OFF position. Allow
approximately 12-24 hours charging time. Recharge until the charging indicator
LED (located on the top of the unit) flashes. Unplug charging adapter after full
charge is reached.
FIGURE 2A - AC ADAPTER
CAUTION:
Use the supplied AC recharge adapter only; do not substitute with any
other. AC recharge requires use of the supplied AC recharge adapter that
supplies 12 volts DC.
FIGURE 2B - DC ADAPTER
4
Advertisement
Table of Contents
