Table of Contents
Advertisement
Empty pans or those with a thin base
Do not heat empty pans, nor use pans with a thin base. The
hob is equipped with an internal safety system. However, an
empty pan may heat up so quickly that the "automatic switch
off" function may not have time to react and the pan may reach
very high temperatures. The base of the pan could melt and
damage the glass on the hob. In this case, do not touch the
pan and switch the hotplate off. If it fails to work after it has
cooled down, please contact the Technical Assistance Service.
Familiarise yourself with the appliance
These instructions for use are applicable to other hobs. On
page 2 an overview of the models is provided, along with
information on measurements.
The control panel
“ VHOHFWLQJ WKH
Control surfaces
Pressing a symbol activates its corresponding function.
The hotplates
Hotplate
Single hotplate
$
Use only cookware suitable for induction cooking; see the section on suitable cookware.
Residual heat indicator
The hob has a residual heat indicator
which lights up when they are hot. Avoid touching them when
this indicator is lit.
The
light will remain on while the hotplate is hot, even after
•
the hob has been turned off.
If the pan is removed before the hotplate is switched off, the
will appear and alternate with the selected power level.
6
&RQWURO SDQHO
IRU
KRWSODWH
SRZHUERRVW IXQFWLRQ °
&RQWURO
SDQHO
IRU
PDLQ
VZLWFK
Turning on and off
Always use cookware of a suitable size.
on each hotplate,
•
Pan detection
Each hotplate has a minimum limit for detecting pans, which
varies depending on the material of the pan being used. You
should therefore use the hotplate that is most suitable for the
diameter of your pan.
,QGLFDWRUV IRU
,QGLFDWRUV IRU
U WLPH SURJUDP
SRZHU OHYHO³É
IXQFWLRQ
IXQFWLRQDOLW\ ¯
&RQWURO SDQHO IRU
UHVLGXDO KHDW ‡
U WLPH SURJUDP
IXQFWLRQ
&RQWURO SDQHOV
IRU
VHOHFWLQJ SRZHU
OHYHO
Notes
The settings will not change if several symbols are pressed at
■
the same time. This enables the programming zone to be
cleaned when food is spilt.
Always keep the control surfaces dry. Moisture can affect
■
proper functioning.
•
&RQWURO SDQHO
IRU
' FKLOGSURRI
ORFN
Advertisement
Table of Contents
