Cooling System; Air Inlet Net; Sholder Strap; Storage - Husqvarna 130BT Operator's Manual

COOLING SYSTEM

• To keep the working temperature as low as possible the machine is equipped
with a cooling system.
(1) Cooling fins on the cylinder.
• Clean the cooling system with a brush once a week, more often in
demanding conditions. A dirty or blocked cooling system results in the machine
overheating which causes damage to the piston and cylinder.

AIR INLET NET

IMPORTANT
• Blown air is taken in from the air inlet net. If the air flow drops during opera-
tion, stop the engine and inspect the air inlet net for blockage by obstacles.
• Note that failure to remove any such obstacles may result in the engine
becoming overheated and damaged.
(1) Net
WARNING
Never use the blower without the net on the blower. Before each use, check that
the net is attached in place and is free from any damage.

SHOLDER STRAP

• If the shoulder strap is damaged it may break during use, thus causing the product
to fall and resulting in personal injury. Follow the instructions below to replace the
shoulder strap with new one.
• Take off the clip from the strap.
• Pass the end of the strap through the hanger.
• Return the clip to the strap.
IMPORTANT
Make sure that the thick round bar of the clips is in the strap.
If it is attached in the wrong way, it leads to serious personal injury.
BEFORE STORING THE BLOWER:
1. Drain the fuel tank and push the primer bulb until it becomes empty of fuel.
2. Remove the spark plug and drop a spoonful of 2-cycle oil into the cylider. Crank the engine several time and install the spark plug.
3. Store unit in a dry, cool and dark, well-ventilated, dust-free place, out of the reach of children.
Maintenance

Storage

F32
F33
(1)
(130BT)
F34
(1)
(350BT, 370BTS, 380BTS)
F35
English
(1)
21