Specifications; Technical Data - Husqvarna 128CD Owner's Manual

Technical data

Engine
Cylinder volume, cu.in./cm
Cylinder bore, inch/mm
Stroke, inch/mm
Idle speed, rpm
Recommended max. speed, rpm
Speed of output shaft, rpm
Max. engine output, acc. to ISO 8893, hp/kW
Catalytic converter muffler
Speed- -regulated ignition system
Ignition system
Manufacturer/type of ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication system
Manufacturer/type of carburetor
Fuel tank capacity, US pint/liter
Weight
Weight without fuel, cutting attachment and guard, lbs/kg
Sound levels (see note 1)
Equivalent sound pressure level at the user's ear,
measured according to ANSI B175.3- -1997, dB(A), min/max: 94/97
Vibration levels
Vibration levels at handles, measured according to ANSI
2
B175.3- -1997, m/s
At idle, left/right handles:
At max. speed, left/right handles:
Note 1: Equivalent noise pressure level is calculated as the time- -weighted energy total for
noise pressure levels under various working conditions with the following time distribution:
1/2 idle and 1/2 max. speed.
NOTE! Noise pressure at the user's ear and vibration on the handles are measured with all the
machine's approved cutting equipment fitted. The table indicates the highest and lowest values.
These attachments used in combination with the specified powerhead have been evaluated
to ANSI B175.3- -2003, "Grass Trimmers and Brushcutters - - Safety Requirements". These
combinations have been evaluated by Underwriter's Laboratories Inc. (UL) and are conse-
quently UL listed:
Model 128CD (3/8 RH arbor shaft thread)
Approved accessories Type
Trimmer head
Model 128LD (M10 LH arbor shaft thread)
Approved accessories Type
Trimmer head
Plastic blades
These accessories used in combination with the specified powerheads have been evaluat-
ed to applicable ISO- - and EN safety requirement standards by the Swedish Machinery
Testing Institute:
Attachments
Edger attachment with shaft
Cultivator attachment with shaft
Blower attachment with shaft
Brushcutter attachment with shaft
Pruner attachment with shaft
115275126 Rev. 1 9/15/09
TECHNICAL DATA
3
TNG7
T25
Tricut 300 mm
128CD
1.7/28
1.4/35
1.130/28.7
2,800- -3,200
10,000
8,000
1.1/0.8
Yes
Yes
Walbro/CD
Champion
RCJ- -6Y
0.024/0.6
Zama
0.85/0.4
10/4.4
3/5
9/8
Cutting attachment / guard, part. no.
537 41 92-14 / 545 03 11-01
Cutting attachment / guard, part. no.
537 33 83-06 / 545 03 09-01
531 00 38- -11 / 545 03 09-01
Part. no.
952 711 607
952 711 608
952 711 609
952 711 610
952 711 612
128LD
1.7/28
1.4/35
1.130/28.7
2,800- -3,200
11,000
8,000
1.1/0.8
Yes
Yes
Walbro/CD
Champion
RCJ- -6Y
0.024/0.6
Zama
0.85/0.4
11/4.8
94/97
3/5
9/8
English--- 22