Table of Contents
Advertisement
—— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Darning
Fabric that has been torn can be darned.
Darning is sewn as shown below.
a Reinforcement stitching
Determine the desired length of the darning.
a
Set the button guide plate on buttonhole foot
"A" to the desired length. (The distance
between the markings on the presser foot scale
is 5 mm (3/16 inch).)
a Presser foot scale
b Length of darning
c 5 mm (3/16 inch)
d 7 mm (1/4 inch)
b
Attach buttonhole foot "A".
• For details, refer to "Replacing the presser
foot" (page 41).
c
Select stitch
• For details, refer to "Selecting stitching" (page
72).
1
2
4
58
59
or
.
d
3
1
1
Position the fabric so that the needle is 2 mm
(1/16 inch) in front of the area to be darned,
and then lower the presser foot lever.
1
2
a Tear
b 2 mm (1/16 inch)
Pass the upper thread down through the hole in
the presser foot.
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
darning will not be sewn with the correct
size.
a Do not reduce the gap.
Reinforcement Stitching 109
3
a
Advertisement
Table of Contents
