Zanussi ZWC1301 User Manual page 20

With a suitable spanner unscrew and remove
the three screws and their spacers on ma-
chine's rear.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or furni-
ture. Level the washing machine by raising or
lowering the two front feet. If necessary, check
the setting with a spirit level. Any necessary ad-
justment can be made with a spanner. Accurate
levelling prevents vibration, noise and displace-
ment of the machine during operation.
Caution! Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in the floor.
Water inlet
Warning! This appliance must be
connected to a cold water supply
20
The three holes must
then be plugged with
the plastic plug caps
supplied in the bag
containing the in-
struction booklet,
which can be found
inside the drum.
Caution! Before connecting up the
appliance to new pipework or to pipework
that has not been used for some time, run off a
reasonable amount of water to flush out any
debris that may have collected
Caution! Do not use the hose from your
previous appliance to connect to water
supply.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The drain hose can be hooked over the edge of
a sink using the plastic hose guide supplied
with the machine. Make sure that the sink is
empty and the plug hole is not blocked.
Connect the hose to
a tap with a 3/4"
thread. Always use
the hose supplied
with the appliance.
The machine end of
the inlet hose can be
turned in any direc-
tion. Set the hose
correctly by loosening
the ring nut. After po-
sitioning the inlet
hose, be sure to
tighten the ring nut
again to prevent
leaks.
www.zanussi.com