Cleaning And Maintenance; Heat Exchanger - Zanussi ZDC68560W User Manual

The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob, the programme progress display and the
maintenance indicators flash. If an option button (exclud-
ing the BUZZER button) is pressed,
the display. The drying programme is not however affec-
ted by this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display shows the
anti-crease icon and flashing as well as warning
lamps: FILTER and TANK . If the
been pressed, an acoustic signal sounds intermittently for
about one minute.
The drying cycles (except from the WOOL pro-
gramme) are automatically followed by an anti-
crease phase which lasts around 30 minutes. The drum

Cleaning and maintenance

Cleaning lint filters
To ensure that the appliance works perfectly, the lint filters
in the door and in front of the drum must be cleaned after
every drying cycle.
Caution! Important. Never operate the dryer without
the lint filter or with a damaged or blocked lint filter.
1. Open loading door
12
appears on
BUZZER button has
2. After a period of time, a
patina due to detergent
residue on laundry forms
on the filters. Then clean
the filters with warm water
using a brush. Remove the
filter from the door pulling
it out.
rotates at intervals during this phase. This keeps the laun-
dry loose and free of creases. The laundry can be removed
at any time during the anti-crease phase. (The laundry
should be taken out towards the end of the anti-crease
phase at the latest to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff from the
micro-fine filter. It is best to use a damp hand for
this purpose. (See "Cleaning and maintenance"
chapter.)
3. Remove laundry.
4.
Turn the programme selector to
5. Close the door.
After each use
• Clean the filters.
• Empty the water reservoir.
3. Use a damp hand to
clean the micro- fine filter,
which is built into the low-
er part of the loading aper-
ture.
Cleaning heat exchanger
Clean the condenser when light Condenser comes on.
The condenser is situated at the lower part of the cabinet
behind a small door.
off.
4. Remove fluff from lint
filter, preferably using a
damp hand for this pur-
pose.
Replace the filter.