Maintenance And Troubleshooting - Weslo Purcuit4.2 Bike Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike
regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace the bat-
teries (see assembly step 11 on page 11); most
console problems are the result of low batteries.
If the handgrip heart rate monitor does not function
properly, see step 4 on page 15.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must first remove the left
pedal and the left shield as described below.
Using an adjustable wrench, turn the Left Pedal (24)
clockwise and remove it. Next, remove all the Screws
(not shown) from the Left and Right Shields (17, 18);
there are two sizes of Screws in the Shields––note
which size of Screw you remove from each hole.
Then, gently pull the Left Shield away from the frame.
24
17
Turn the Resistance Knob (27) to the lowest setting.
Then, locate the Reed Switch (43). Turn the Pulley (21)
until the Magnet (38) is aligned with the Reed Switch.
Loosen, but do not remove, the M4 x 16mm Self-
tapping Screw (47).
Slide the Reed Switch (43) slightly closer to or away
from the Magnet (38), and then retighten the M4 x
16mm Self-tapping Screw (47). Turn the Pulley (21) for
a moment.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the left shield and the left pedal.
18
18
21
38
43
47
27