Vector TOUGH BRITE VEC146 Owner's Manual & Warranty
Vector TOUGH BRITE VEC146 Owner's Manual & Warranty

Vector TOUGH BRITE VEC146 Owner's Manual & Warranty

Tough brite 6-volt lantern cordless, rechargeable

Advertisement

TUFGG Lantern
6-VOLT LANTERN
IF YOU SHOULD EXPERIENCE A PROBLEM WITH YOUR
VECTOR PURCHASE, CALL TOLL FREE (866) 584-5504. IN
MOST CASES A VECTOR SERVICE REPRESENTATIVE CAN
RESOLVE YOUR PROBLEM OVER THE PHONE.
IF YOU HAVE A QUESTION OR COMMENT, GIVE US A
CALL, YOUR FEEDBACK IS IMPORTANT TO US.
KEY INFORMATION YOU
SHOULD KNOW:
This unit contains a built-in 110/120
volt AC charger. Use any household
type extension cord for recharging.
TO CHARGE: Charge 28 hours before first use.
TO OPERATE: Simple two-position pushbutton.
ADJUSTABLE 4-Position Beam
THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY,
OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. READ CARE-
FULLY BEFORE USE, AND RETAIN FOR FUTURE REFERENCE.
4140 S.W. 28th Way, Ft. Lauderdale, FL 33312
Tel: (954) 584-4446 Fax: (954) 584-5556 Toll Free: (866) 584-5504
TOUGH BRITE
Cordless, Rechargeable
CORDLESS, RECHARGEABLE
OWNER'S MANUAL
& WARRANTY INFORMATION
www.vectormfg.com
VEC146
TM

Advertisement

Table of Contents
loading

Summary of Contents for Vector TOUGH BRITE VEC146

  • Page 1: Warranty Information

    Cordless, Rechargeable CORDLESS, RECHARGEABLE IF YOU SHOULD EXPERIENCE A PROBLEM WITH YOUR VECTOR PURCHASE, CALL TOLL FREE (866) 584-5504. IN MOST CASES A VECTOR SERVICE REPRESENTATIVE CAN RESOLVE YOUR PROBLEM OVER THE PHONE. IF YOU HAVE A QUESTION OR COMMENT, GIVE US A CALL, YOUR FEEDBACK IS IMPORTANT TO US.
  • Page 2: Key Features

    1-800-822-8837 8. Recharge after each use or every 60 days. See instructions for proper charging techniques. Contact Vector Customer support for replacement parts or questions. (954) 584-4446 or toll free at (866) 584-5504. INTRODUCTION Congratulations on purchasing the TOUGH BRITE 6-VOLT LANTERN.
  • Page 3: Operation

    FIGURE 1 Lantern ON/OFF Switch (4) Position Release LED Charging Pushbutton (3) Bezel (2) Indicator (5) LED Area Light Lens (1) ON/OFF Switch (6) AC Charge Port (7) LED Area Light (8) OPERATION A two-position ON/OFF toggle switch controls the operation of the lantern. The lantern can be continuously lit for up to 1-1/2 hours on a full battery charge.
  • Page 4: Battery Disposal

    DC CHARGING DO NOT operate Lantern while charging. Make sure that the DC charger is powered from the correct DC source. Use only the DC charger cord supplied with this unit. Use of any other may damage the Lantern's internal charging circuits and void the warranty. To recharge the Lantern simply plug the barrel end of the DC cord into the Lantern.
  • Page 5: Specifications

    Length .....9.0 in (22.9 cm) Base width/depth ... .4.0 x 8.5in (10.2 x 21.6 cm) NOTE: A H3, 6 volt, 15-watt quartz halogen may be used if a Vector replacement bulb is not available.
  • Page 6: Bulb Replacement

    10. Insert the replacement 55-watt quartz halogen bulb assembly into the reflector flange. 11. Reverse the proceeding procedure to reassemble the Lantern. Replacement Lantern bulb assemblies are available from an electrical supply house. You may also call Vector’s parts desk toll free (866) 584-5504 or visit our web site at www.vectormfg.com...
  • Page 7: Battery Care

    When the Lantern is not in use, Vector recommends that the battery is recharged at least every 60 days. All batteries must be recharged as soon as possible after each use.
  • Page 8 30 days of the date of purchase will be replaced free of charge. If such a product is returned more than 30 days but less than two years from the purchase date, Vector Manufacturing will repair the unit or, at its option, replace it free of charge.

Table of Contents