Battery Disposal - Vector TOUGH BRITE VEC146 Owner's Manual & Warranty

DC CHARGING
DO NOT operate Lantern while charging.
Make sure that the DC charger is powered from the correct DC source. Use only
the DC charger cord supplied with this unit. Use of any other may damage the
Lantern's internal charging circuits and void the warranty.
To recharge the Lantern simply plug the barrel end of the DC cord into the Lantern.
Insert the large plug into any vehicle, portable or converter 12 volt DC power
source.
Observe that the red LED lights, this indicates the Lantern is charging. A flashing
red LED indicates the Lantern is fully charged.
OBSERVE ALL CAUTIONS AND WARNINGS.
NOTE: Recharging battery after each use will prolong battery life; frequent heavy
discharges between recharges will reduce battery life. The time required
to fully recharge the battery depends on the charge status of the battery
after it's use or storage. If the battery is discharged, recharge the battery
until the red LED changes from steady lit to flashing.

BATTERY DISPOSAL

Non-Spillable Sealed Lead Acid Battery: This battery is fully recyclable
and should be accepted at any location that accepts common
automotive starter batteries. Examples of places that accept these
ALWAYS RECYCLE
batteries are: county or municipal recycling drop-off centers, scrap metal dealers
and retailers who sell automotive replacement lead acid starter batteries. For more
information on recycling this battery, call toll-free (877) 288-7722.
BATTERY DISPOSAL WARNINGS:
1. Do not dispose of the battery in fire as this may result in an explosion.
2. Before disposing of the battery, protect exposed terminals with heavy-duty
electrical tape to prevent shorting (shorting can result in injury or fire).
3. Failure to comply with local, state and federal regulations can result in fines,
or imprisonment.
3