Bulb Replacement - Vector TOUGH BRITE VEC146 Owner's Manual & Warranty

1
FIGURE 2 BULB ASSEMBLY

BULB REPLACEMENT

If you suspect the bulb is burned out:
A Phillips screwdriver is the only tool required to replace the bulb; (replacement
bulb H3 6 volt 15-watt Halogen quartz is required). The replacement procedure is
as follows:
1. Make sure the Lantern switch is in the OFF position.
2. Pull the rubber bezel from the Lantern's reflector.
3. Using the Phillips screwdriver, unscrew two screws that secures the plastic
band around the lens of the Lantern.
4. Lift the plastic band from the lens and carefully separate the lens glass and rubber
gasket.
5. Carefully lift the reflector (1) and bulb assembly (3) out of the housing.
6. Unsnap the retaining wire (2) from the reflector's flange by pinching the two ends
together and lifting.
7. Loosen the Phillips-head retaining screw (4) (no need to completely remove) to
remove the bulb assembly from the reflector.
8. Slightly turn and lift out the bulb assembly from the back of the reflector.
9. Disconnect the bulb assembly (white wire) from the red power wire by separating
the male spade terminal from the female terminal.
10. Insert the replacement 55-watt quartz halogen bulb assembly into the reflector
flange.
11. Reverse the proceeding procedure to reassemble the Lantern.
Replacement Lantern bulb assemblies are available from an electrical supply house.
You may also call Vector's parts desk toll free (866) 584-5504 or visit our web site at
www.vectormfg.com
2
1. Reflector
2. Retaining Wire
3. Bulb Assembly
4. Retaining Screw
5
3
4