Using The Husky Jump-Start System; Recommendations For Optimum Performance Of The Husky Jump-Start System - Husky Jump-Start System HSK020HD Owner's Manual

Figure 1
Safety Switch
Positive Battery
Clamp
Worklight
ON/OFF
Switch
WARNING: Automotive lead-acid batteries can generate hydrogen gas during normal
operation. More gas is generated when the battery is charging. Hydrogen
gas is: • Explosive • Poisonous to Breathe • Highly Flammable
To avoid an explosion and/or the possibility of being splashed with battery acid:
• NEVER allow the red and black clamps to touch each other or a common metal object
• ONLY attempt to jumpstart a vehicle, boat or engine system in a WELL ventilated area
• ALWAYS CONNECT THE RED (+) CLAMP TO THE POSITIVE (+) BATTERY
TERMINAL FIRST
• DO NOT CONNECT THE BLACK (–) CLAMP TO THE NEGATIVE (–) BATTERY
TERMINAL
• DO CONNECT THE BLACK (–) CLAMP TO A NON-MOVING METAL PART ON
THE ENGINE
CAUTIONS:
I. To avoid possible damage that may shorten the unit's working life, protect this unit
from direct sunlight, direct heat, and/or moisture.
2. This system is to be used ONLY on vehicles, boats, garden tractors and gasoline
powered generators with 12 volt DC battery systems.
3. This system is NOT designed to be installed as a replacement for a vehicular battery.
RECOMMENDATIONS FOR OPTIMUM PERFORMANCE OF THE HUSKY
JUMP-START SYSTEM
WARNING: Never insert anything other than the supplied power/recharging cords or
recommended appliance power/recharging cords into the charging or
power receptacles on this unit.
IMPORTANT: The Safety ON/OFF Switch should be in the OFF position
when the unit is charging, or not in use.

3. USING THE HUSKY JUMP-START SYSTEM

WARNINGS:
1. Before using this system to Jump-Start any vehicle or boat, read and understand all
instructions, safety tips, warnings, cautions and first aid information provided in this
manual and on the product labeling. Additional important information may also
be provided by the vehicle's battery system manufacturer.
2. Be aware of first aid procedures before attempting jumpstart procedure.
3. ALWAYS wear protective eyewear when working with a lead acid-type battery.
8
Worklight
™
AC/DC Recharge Port
Red LEDs
Full Green LED
Battery Status Push button
Negative Battery Clamp
12 Volt Accessory Socket (DC Recharge)