Camera System Adjustments; Adjustment Points When Major Parts; Have Been Replaced; Initialization Of Page F Data - Sony DCR-PC10 Service Manual

1-2.

CAMERA SYSTEM ADJUSTMENTS

1-2-1. Adjustment Points When Major Parts Have
Been Replaced
When the CCD imager or lens block is replaced, adjust the items
indicated by ® in the following table.
When the CCD
imager is replaced
HALL adjustment
Flange back adjustment
IRIS IN/OUT adjustment
MAX GAIN adjustment
Color reproduction
adjustment
Auto white balance
reference data input
Auto white balance
adjustment
1-2-2.

Initialization of Page F data

Note 1: Execute the initialization of page F only when the non-
volatile memory (VC-199 board IC202 EEPROM) is
replaced.
Note 2: If the page F data has been initialized, all adjustment items
of the camera section must be executed again.
Initializing procedure:
Order Page Address
1
2 6 00
3 6 01
4 6 03
5 6 02
Works required after initialization
Order Page Address
1 6 00
2
3
When the lens
block is replaced
®
® ®
® ®
®
®
®
®
Data
Turn OFF and ON the main power supply. (Preparation)
01 Set the data.
2D:NTSC After setting the data, press the PAUSE button.
2F:PAL
01 After setting the data, press the PAUSE button.
Confirm that the data is 01.
Data
00 Set the data.
Turn off the main power supply. (End)
Perform the next item "1-2-3. Page F Data Modifications", then execute all adjustment
items of the camera section.
Note: Check that the following adjustment has been completed
before performing "Camera Check Adjustments".
1. "Initializing the Page D Data" and "Changing the Page
D Data" of "System Control System Adjustments" of
"Video Section Adjustments".
2. "Base Band Block Adjustment" and "Clock Adjustment"
of "Video System Adjustments" of "Video Section
Adjustments".
Procedure
Procedure
5-5