Adjusting The Seat; Attaching The Power Pak - Weider Platinum Plus 1000 User Manual

ADJUSTING THE SEAT

The Seat (25) can be secured at various positions on
the Rail (5). To move the Seat, pull the Seat Knob
(138) out as far as it will go and slide the Seat to the
desired position. Engage the Seat Knob into an
adjustment hole in the Rail.
To perform row exercises, the hip strap must be
attached to the rope (see ATTACHING THE ACCES-
SORIES on page 17), and the Seat Carriage (16)
must be able to roll along the Rail (5). First, remove
the backrest from the seat carriage (see ADJUSTING
THE BACKREST on page 18). Then, pull the Seat
Knob (138) out as far as it will go, and turn the Seat
Knob so that the pin rests at the end of the "L"-
shaped slot (see the inset drawing).

ATTACHING THE POWER PAK

Set the Threaded Spacer (191) into the groove on the
Max Pack Frame (54). Insert the Pin (193) through
the Side Mech Cover (81), the Top Endcaps (186,
187), and the Mech Frame (124). Fully tighten the
Pin.
Attaching the MAX PACK to your resistance system
will increase your minimum and maximum resistance
levels. The resistance system can be used at a lower
resistance level again by removing the MAX PACK.
25
16
5
Adjustment
Hole
19
138
"L"-Slot
Pin
193
81
124
187
186
54
191
16
138