Page 1
VIVOTEK Fixed Dome Series AM-102 Recessed-mount Bracket User’s Manual Rev. 1.0 IP Sur veillance...
Page 2
Compatible VIVOTEK Cameras Fixed Dome series FD8162, FD8135H You may also refer to VIVOTEK's website for the list of supported models. Support for other models can be available through time. IMPORTANT: Before installing your camera, make sure the built-in PIR (Passive Infrared Sensor) can be directed toward the area of interest, where possible intrusion may occur.
Installation Mounting Hole Definitions 1. Determine a secure location for the recessed-mount bracket. 2. Drill or cut a 186mm hole (in diameter). The maximum thickness of the ceiling/board is 24mm. The ceiling should be able sustain at least a weight of 1.4kg. 186mm Up to 24mm...
Page 4
4. Use the included stardriver to detach the dome cover from the recessed mount. 5. Install camera to the recessed-mount bracket by driving 2 screws.
Page 5
NOTE: 1. Connect and route cables before you secure the recessed-mount bracket to a ceiling. 2. For details on the cable connections with each camera, please refer to their Quick Installation Guide. Optional: You can tie up a tether line to the top of the bracket in case the bracket may fall during the installatioin.
Page 6
6. Connect cables to the camera. 7. Use a #2 Phillips screwdriver to loosen the clamping plates (see drawing below) and insert the recessed-mount bracket through the hole in the ceiling. 8. Use a #2 Phillips screwdriver to move the clamping plates down so that the ceiling/ board is caught between the clamps and the flange on the other side of the ceiling.
Page 7
9. Adjust shooting angle and check for a satistory image over a web session. When you have a satisifactory live view, secure the dome cover from below the ceiling using a T10 stardriver.