GE JBP74 Owner's Manual page 37

Problem
Excessive smoking
during a clean cycle
Oven door will not
open after a clean cycle
Oven not clean after a
clean cycle
"LOCK DOOR" flashes
in the display
LOCKED DOOR light
is on when you want
to cook
"F—and a number
or letter" flash
in the display
Control signals after
entering cooking time
or start time
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
Possible Causes
Excessive soil.
Oven too hot.
Oven controls not properly set. • See the Using the self-cleaning oven section.
Oven was heavily soiled.
The self-clean cycle has been • Close the oven door.
selected, but the door is not
closed.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
You have a function error code. • Touch the CLEAR/OFF pad. Put the oven back into
If the function code repeats.
You forgot to enter a
bake temperature or
cleaning time.
A fuse in your home
may be blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Power failure.
Oven control pads were
not touched properly.
Power outage or surge.
What To Do
• Touch the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until the LOCKED door
light goes off. Wipe up the excess soil and reset the
clean cycle.
• Allow the oven to cool below locking temperature.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
• Touch the CLEAR/OFF pad. Allow the oven to cool.
operation.
• Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Touch the BAKE pad and desired temperature or
the SELF CLEAN pad and desired clean time.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
ge.com
37