Basic Operation Of Cd - Pioneer DVH-P7000R Operation Manual

Playing CDs on the
built-in player

Basic operation of CD

1 Press on the head unit to open the
OPEN
front panel.
Disc loading slot appears.
• After inserting a CD, press
the built-in player.
• Pressing on the head unit also per-
SOURCE
forms the same operation.
2 Insert a CD into the Disc loading slot.
When you set
AUTO PLAY: ON
automatically start. If you set
press to select
SOURCE
Disc loading slot
button
EJECT
• You can eject a CD by pressing
head unit.
• To avoid a malfunction, make sure that no
metal object comes into contact with the front
panel is open.
3 After a CD has been inserted, close the
front panel.
4 Use to adjust the sound level.
VOLUME
Press to increase or decrease the vol-
VOLUME
ume level.
• Rotating on the head unit also
VOLUME
increases or decreases the volume.
5 To skip back or forward to another track,
press 4 or ¢ .
Track numbers are displayed for 8 seconds.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
to select
SOURCE
, playback will
,
AUTO PLAY: OFF
(refer to page 17).
DVD
on the
EJECT
• If the remote control is set to
4 and ¢ do not operate. In this case,
press 1 or ¡ to skip to another track.
6 To perform fast forward or reverse, press
and hold 1 or ¡.
• Pressing and holding 2 or 3 on the head unit
also performs the same operation.
• If you continue pressing 1 or ¡ for 5
seconds, the color of the fast reverse/fast
forward mark (
white to blue. When this happens, fast
reverse/fast forward continues even if you
release 1 or ¡. To resume playback at a
desired point, press 6.
• If you fast forward to the end of a CD, fast
forward continues from the beginning of
the disc.
• If you fast reverse to the beginning of a CD,
normal playback resumes.
Notes
• The built-in player plays one, standard,
12-cm or 8-cm (single) CD at a time. Do not
use an adapter when playing 8-cm CDs.
• Do not insert anything other than a
DVD/Video CD/CD into the Disc loading slot.
• If you cannot insert a disc completely or if
after you insert a disc the disc does not play,
check that the label side of the disc is up.
Press to eject the disc, and check the
EJECT
disc for damage before inserting the disc
again.
• If the built-in player does not operate properly,
an error message such as
displayed. Refer to Error messages on page 97.
mode,
DVH
/ ) changes from
may be
ERROR-11
En
Section
07
47