Table of Contents
Advertisement
Appendix
Additional Information
Message
ERROR-02-XX
DIFFERENT REGION DISC (RE-
GION ERR)
NON-PLAYABLE DISC (NON-
PLAY)
NON-PLAYABLE FILE (NON-
PLAY)
THERMAL PROTECTION IN
MOTION (TEMP)
FILE Skipped
PROTECT
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message
Error. Please check MIC.
Error. Please check front SP.,
Error. Please check FL SP.,
Error. Please check FR SP.,
Error. Please check center SP.,
Error. Please check rear SP.,
Error. Please check RL SP.,
Error. Please check RR SP.,
Error. Please check rear center
SP., Error. Please check sub-
woofer.
118
En
Cause
Dirty disc
Scratched disc
The disc is loaded upside down
Electrical or mechanical
The disc does not have the same re-
gion number as this unit
This type of disc cannot be played
by this unit
The inserted disc does not contain
any files that can be played back
The inserted disc contains DivX
video files that cannot be played by
this unit.
The temperature of this unit is out-
side the normal operating range
The inserted disc contains WMA
files that are protected by DRM
All the files on the inserted disc are
secured by DRM
Cause
Microphone is not connected.
The microphone cannot pick up the
measuring tone of a speaker.
Action (See)
Clean disc.
Replace disc.
Check that the disc is loaded correctly.
Press RESET.
Replace the DVD video with one bearing the
correct region number.
Replace the disc with one this unit can play.
Replace disc.
! Switch to the other file that can be played
by this unit.
! Replace disc.
Wait until the unit's temperature returns to
within normal operating limits.
! Play an audio file not protected by DRM.
! Replace disc.
Replace disc.
Action
Plug the supplied microphone securely into
the jack.
! Confirm that the speakers are connected
correctly.
! Correct the input level setting of the power
amp connected to the speakers.
! Set the microphone correctly.
Advertisement
Table of Contents
