Table of Contents
Advertisement
Section
11
Initial Settings
Adjusting the brightness
You can adjust the display brightness.
1
Display the initial setting menu.
Refer to Adjusting initial settings on page 49.
2
Use MULTI-CONTROL to select
Brightness in the initial setting menu.
3
Push MULTI-CONTROL left or right to
adjust the brightness level.
0 to 15 is displayed as the level is increased or
decreased.
# When dimmer is functioning, the brightness
level can be adjusted 0 to 10.
Setting the rear output and
subwoofer output
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Rear SP :F.Range) or subwoo-
fer (Rear SP :S/W) connection. If you switch
the rear output setting to Rear SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (Rear SP :F.Range).
1
Display the initial setting menu.
Refer to Adjusting initial settings on page 49.
2
Use MULTI-CONTROL to select
S/W control in the initial setting menu.
3
Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will switch be-
tween Rear SP :F.Range (full-range speaker)
and Rear SP :S/W (subwoofer) and that status
will be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :F.Range (full-range speak-
er).
# When a subwoofer is connected to the rear
output, select Rear SP :S/W (subwoofer).
52
En
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
46).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1
Display the initial setting menu.
Refer to Adjusting initial settings on page 49.
2
Use MULTI-CONTROL to select
Demonstration in the initial setting menu.
3
Press MULTI-CONTROL to turn the fea-
ture demo on.
# To turn the feature demo off, press
MULTI-CONTROL again.
Notes
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
! You can also turn on or off feature demo by
pressing DISP/SCRL while this unit is turned
off. For more details, refer to About the demo
mode on page 8.
Switching the reverse mode
If you do not perform an operation for about
30 seconds, screen indications start to reverse,
and continue reversing every 10 seconds.
Hide quick links:
Advertisement
Table of Contents
