Thane Housewares H2O Mop User Manual page 6

U S E R ' S G U I D E
3 ) I n s e rt handle down into the body.
4 ) Once the handle is placed inside the body, slide the silicon ring which is already located on the handle to the
bottom. Make sure the ring is positioned tightly so there is no gap between the handle and body.
5 ) S c rew the Large Philips Head screw through the opening at the back of the body into the rear of the handle,
tighten with screwdriver until secure .
6 ) Place the Microfiber Cloth Pad or disposable pad (optional item) onto the mop head.
Note: Microfiber Cloth is washable while the disposable pad (optional item) is intended for one-time use.
7) Fasten the Microfiber Cloth Pad by pulling the cord while pressing on Toggle. Note: this step is not re q u i red if
you are using disposable pad (optional item). Disposable pad comes with built in elastic cord .
8) When using H2O Mop on carpets, place the mop head (with microfiber cloth or disposable pad in place) over the
Carpet Glider.
NOTE: Do not operate without either Microfiber Cloth or disposable pad (optional item) in place.
5
U S E R ' S G U I D E
9 ) To remove the Water tank push it up and detach from the body as shown below.
10) Please pour two measuring cups of water into the Water tank (The MAX is 800ml/27oz, do not try to over fill).
11) To remove the Water Filter push it up and detach from the body.
12) Twist the Quick Release Cord Wrap clockwise to unwrap the Power Cord completely and plug into a grounded outlet.
13) When plugged in, the LED light located on the front of the H2O Mop body will be red. After 20-25 seconds, the
light will change to green, meaning the Mop is ready to emit steam. To release steam, press the trigger located on
the handle, and the unit will start releasing steam. To stop releasing steam, press the trigger again.
14) Slowly pass over surface to be cleaned. It is recommended to sweep or vacuum floor prior using the H2O M o p .
N O T E : It is recommended that another high wattage appliance is not operated on the same circuit to avoid a circ u i t
o v e r l o a d .
C A U T I O N : To sanitize an area of your floor, leave the H2O Mop over area for a minimum of 8 seconds, but no longer
than 15 seconds. Leaving the H2O Mop in a stationary position for a longer period than recommended may cause
the build up of a pale residue. This residue can be removed by using a decalcifying product or with a few drops of
v i n e g a r. (See troubleshooting guide)
6