Table of Contents
Advertisement
Contact Output Reset Signals (Contact Output Resets):
These are the logic signals associated to the contact output reset, which produce the reset of those signals previously
configured as Latched. The status of these signals is obtained at Actual > Status > Contact Outputs Resets >
Board X, being X the corresponding I/O board. The name of these outputs is the same for the mixed and supervision
boards, the only difference will be the slot where the output is located in the relay (slot F, G, H or J). These signals
can be configured at Setpoint > Relay Configuration > Outputs > Contact Output Reset
IO Board Status:
These signals are associated to the different I/O boards. There are internal signals that provide information about the
status of these boards, indicating whether there is any anomaly in the board, or whether the board is not available in
the relay according to the relay model. This information can be accessed at Actual > Status > IO Board Status.
38
I/O MODULES DESCRIPTION
TABLE 5-5 CONTACT OUTPUT RESETS
CONTACT OUTPUT RESETS
(X: board F, G, H, J)
CONT OP RESET_X_01
CONT OP RESET_X_02
CONT OP RESET_X_03
CONT OP RESET_X_04
CONT OP RESET_X_05
CONT OP RESET_X_06
CONT OP RESET_X_07
CONT OP RESET_X_08
TABLE 5-6 I/O BOARD STATUS
BOARD STATUS
BOARD F STATUS
BOARD G STATUS
BOARD H STATUS
BOARD J STATUS
CIO Remote CAN Digital I/O Module
GEK-106465A
Advertisement
Table of Contents
