Miller Electric Three-Phase Running Gear Owner's Manual

OWNER'S MANUAL
Three-Phase Running Gear (042 886), Weld Cable Holder (043 055),
Cylinder Rack/Lift (043 005), And Stationary Cylinder Rack (042 887)
WARNING
ELECTRIC SHOCK can kill.
Do not touch live electrical parts.
Turn Off welding power source and input disconnect
device.
Disconnect
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
Keep cylinders away from welding and other
electrical circuits.
Never touch cylinder with welding electrode.
Always secure cylinder to running gear, wall, or
other stationary support.
1
2
3
4
1
2
3
4
7
When installing Weld Cable
Holder Kit 043 055, use
same holes in welding pow-
er source that are used to in-
stall Three-Phase Running
Gear handle.
input power conductors
7
6
5
7
6
5
4
14
15
18
17
16
Figure 1. Installing Three-Phase Running Gear
FORM: OM-687
December 1998
FALLING EQUIPMENT can cause injury
and damage.
Use proper equipment to lift unit.
Use lifting forks long enough to extend out opposite
side of base.
from
Do not put any body part under unit while lifting.
For more weld cable
wraps around handle,
install handle in this
position.
Shim (8) is installed as a
spacer when cylinder
rack is not used.
10
When installing running gear and cylinder rack at the
same time, install axle according to Figure 2 or Figure 4.
Tools Needed:
3/8, 7/16, 9/16, 5/8 in
Item Part
No. No. Description (Qty)
1 +601 865 Nut, 1/4-20 (2)
2 +602 207 Washer, 1/4 lock (2)
3 +602 241 Washer, 1/4 flat (2)
4 +168 342 Upright Handle (2)
5 +168 341 Front Handle (1)
6 +098 877 Screw, 1/4-20 x 2-1/4 (2)
7 +049 966 Screw, 1/4-20 x 1-1/2 (6)
8 163 444 Shim (2)
9 163 446 Axle (1)
10 604 224 Screw, 1/4-20 x 3/4 (6)
11 602 250 Washer, 13/16 flat (2)
12 121 614 Retaining Ring (2)
13 163 463 Wheel, 10 in (2)
14 601 965 Screw, 3/8-16 x 1 (8)
15 163 442 Caster Mounting Bracket (1)
16 168 247 Caster (2)
17 601 872 Nut, 3/8-16 (8)
18 602 213 Washer, 3/8 lock (8)
+These items are common to Kit Nos. 042 886
and 043 055.
Be sure to provide Model when ordering
replacement parts.
8
9
10
Remove paint from axle grooves (9)
before installing retaining rings (12).
11
12
13
164 063D
miscwarn1.1 5/93
ST-800 213-B