Handling Selphy - Canon SELPHY CP900 User Manual

Handling SELPHY

Do not apply strong force or vibration. This may cause paper jams or the printer to malfunction.
O
Do not expose SELPHY to insect sprays and volatile liquids. Do not allow SELPHY to be in contact with
O
rubber or plastic products over a long time. This may deteriorate the external casing.
Depending on the room temperature, SELPHY may overheat and temporarily stop operating. This is not
O
a malfunction. Wait for a while untill SELPHY cools down and restarts operating. Printing may take longer
when continuously printing, the room temperature is high, or SELPHY's rear air vent
because SELPHY will temporarily stop printing due to overheating.
When moving SELPHY from a cold place to a warm place, insert SELPHY in an airtight plastic bag
O
in advance and remove after SELPHY has reached room temperature to avoid condensation. If
condensation forms, leave SELPHY in room temperature until the condensation evaporates naturally.
Clean SELPHY with a soft dry cloth.
O
If dust accumulates on the air vent
O
printing results may not be clean if dust gets in from the air vent.
Never clean SELPHY with solvents such as benzine or thinner, or mild detergent. This may
O
deteriorate or deform the external casing, or the coating may peel off.
Trademarks and Licenses
DCF is a collective trademark of Japan Electronics and Information Technology Industries Association and
O
a registered trademark in Japan.
The SDXC logo is a trademark of SD-3C, LLC.
O
Wi-Fi , Wi-Fi Alliance
®
O
trademarks of Wi-Fi Alliance.
This product is implemented with exFAT technology licensed by Microsoft.
O
About this Guide
Reprinting, transmitting, or storing in a retrieval system any part of this guide without the permission of
O
Canon is prohibited.
Canon reserves the right to change the contents of this guide at any time without prior notice.
O
Illustrations and screenshots in this guide may differ slightly from the actual equipment.
O
The above items notwithstanding, Canon accepts no liability for damages resulting from the use of this
O
product and software.
54
(p. 6), remove the ink cassette
, WPA , WPA2 , and Wi-Fi Protected Setup
® TM TM
(p. 6)
(p. 14) and clean away the dust. The
are trademarks or registered
TM
is blocked