Light Bulb Replacement - GE Spacemaker JVM230 Use And Care Manual

Cooktop Light
To replace
cooktop light,
first disconnect
power at main
fuse or circuit
breaker panel
or pull plug.
Remove screw on right side of light compartment
cover and lower cover until it stops.
Oven Light
To replace your oven light, first
disconnect power at main fuse
or circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold
it in place.
22

LIGHT BULB REPLACEMENT

REMOVE SCREW
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt incandescent bulb
(WB02X4235), available from
your GE supplier.
Be sure bulbs
to be replaced
are cool before
removing. Break
the adhesive seal
by gently
unscrewing the
bulbs. Replace
with 40-watt incandescent bulbs (WB02X4253)
available from your GE supplier.
High intensity 40-watt bulbs (40S11N/1), which are
available in supermarkets and hardware stores,
may also be used for replacements. Raise light
compartment cover and replace screw. Connect
electrical power to microwave oven.
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About 1 tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.