Advertisement
REMOVE SCREW
To replace
disconnect fiwer at main
first
fuse or circuit breaker panel or
pull plug.
Remove screw on right
side of light compartment cover
and lower cover until it stops.
Be sure bulbs to be replaced are
cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs (Part No.
GE supplier. High intensity 40-watt
bulbs (Part No. 40SllN/1) which
are available in supermarkets and
hardware stores may also be used
for replacements. Raise light
compartment cover and replace
screw. Connect electrical power to
microwave oven.
Oven Li@t
To replace
your oven light, first
disconnect power at main fuse or
circuit breaker or pull plug.
Remove the top grill by taking off
3 screws which hold it in place.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Remove bulb and replace with
a 30-watt GE bulb (Part No.
GE supplier. Secure light housing
with screw.
29
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
WARNING–improper
use of the grounding plug can result
in a risk o~electric =hoc~.
INSURE PROPER
GROUND EXISTS
BEFORE USE
Fig. 1
I
Consult a qualified electrician or
service technician if the groundin~
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circ~ce
cut or remove the third @round)
prong from the power cord.
Do not use an adapter plug
with this appliance.
Do not use an extension cord
with this appliance.
Advertisement
