Layout File Format - Mackie C4 Commander Programming Manual

<RotaryStyle> Indicates the rotary type for the
V-Pot. Default is 1.
0: Rotary action has no effect.
1: Dot — single LED light ranged from
min to max.
2: Boost/Cut — multiple LEDs starting
at the center top, traveling down the
left or right side. Commonly used for
pan effects.
3: Wrap — similar to Dot except multiple
LEDs fill to the current position.
4: Spread — similar to Boost/Cut except
LEDs on left and right are symmetric.

Layout File Format

<CustomLayout>
<LayoutID>75a1e4445dcd311d</LayoutID>
<LayoutName>line6 podtr</LayoutName>
<Control>
<ControlID>0<ControlID>
<InstrumentID>7e5b1549-c3c6-4f59-a445-23bca5f06b85</InstrumentID>
<ParamID>0</ParamID>
<Channel>1</Channel>
<Display1>Controllers</Display1>
<Display2>Bank Select</Display2>
<ValueRangeMin>0</ValueRangeMin>
<ValueRangeMax>127</ValueRangeMax>
<Value>0</Value>
<ToggleResetValue>64</ToggleResetValue>
<RotaryStyle>1</RotaryStyle>
<ToggleStyle>0</ParamID>
<RotaryStepSize>1</RotaryStepSize>
<RotaryMegaStepSize>0</RotaryMegaStepSize>
<RotaryMicroStepSize>0</RotaryMicroStepSize>
</Control>
<DisplayGroups>
<DisplayGroup bars="true" pickets="true">
<GroupName>Effects</GroupName>
<StartControl>8</StartControl>
<GroupLength>8</GroupLength>
</DisplayGroup>
.
.
</DisplayGroups>
<PageList>
<Page>Line 6 POD Amp</Page>
<Page>FX Deep Editing</Page>
<Page>Page 3</Page>
.
.
</PageList>
</CustomLayout>
<RotaryStepSize> The amount to increment
the parameter value for each step change of the
rotary V-Pot. Default is 1.
<RotaryValue> The previous value of the pa-
rameter the V-Pot had when the layout was last
used. Default will be half way between the min
and max.
<ToggleResetValue> The value to set the
param to upon "quick" toggle action of the V-
Pot. Default will be half way between the min
and max.
C4 Commander
Programmer's Guide
11