Additional Wireless Settings - TRENDnet AC750 User Manual

TRENDnet User's Guide
In the diagram below, the blue color represents the WDS wireless bridged connections
between the routers. The green color represents access point mode connections
between wireless client devices and the routers.
Note: Before configuring WDS, please ensure the following first:
1. Make sure different IP addresses are assigned to each WDS supported wireless
device used for bridging. (ex. 192.168.10.1,192.168.10.2, 192.168.10.3) to avoid
IP address conflict. See page 34 for changing the LAN IP address.
2. If you are using more than one WDS supported router, please make sure the LAN
DHCP server is enabled on only one and disabled on all others to avoid IP address
conflict. See page 35 for DHCP server options.
3. Configure the same wireless channel and use the same on all WDS supported
wireless devices. See page 20 for configuring basic wireless settings.
4. Configure the same wireless security and key on all WDS supported devices. See
page 15 for configuring wireless security settings.
To configure WDS bridging between TEW-810DRU routers:
1. Log into your router management page (see
on page 15).
2. Click on the Advanced tab.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your router management page"
3. Select wireless band you would like to configure, Wireless 2.4GHz or Wireless 5GHz
and click on WDS.
4. Select Enable for WDS and enter the MAC address of the other WDS supported
wireless device you are bridging next to AP MAC Address field. (e.g.
00:11:22:AA:BB:CC). To save settings, click Apply.
For additional routers, make sure to disable the DHCP server first on all additional
routers and configure the LAN IP address to be different on each router. You will
connect devices to the LAN ports 1-4 only on all additional routers and the WAN port is
not used. Then, repeat the steps for additional routers you are bridging.

Additional wireless settings

Advanced > Wireless (2.4GHz or 5GHz) > Advanced
These settings are advanced options that can be configured to change advanced
wireless broadcast specifications. It is recommended that these settings remain set to
their default values unless you are knowledgeable about the effects of changing these
values. Changing these settings incorrectly can degrade performance.
TEW-810DR
31