Wired Lan Mac Address Filters - TRENDnet AC1750 User Manual

TRENDnet User's Guide
2. Click on Advance, click on Access Control.
3. Select Enable on the pull down menu of Web URL Filter Function. .
4. Review the settings under LAN Client Filter Rules section. Click Apply to save settings.
• IP Range – Enter the IP address or IP address range to apply URL Filter (e.g.
192.168.10.20-192.168.10.20 or 192.168.10.20-192.168.10.30).
Note: The filter will not be applied to IP addresses outside of the range
specified. You can leave the field blank to enable the rule for the entire LAN
clients.
• URL: Enter the URL you would like deny access. Port Range: Enter the port or port
range to apply the protocol.
• Schedule: Select the defined schedule you would like to have the rule to be
applied. (see "Set Schedule" section on page 32).
• Enabled: Selecting Enable turns on the filter
© Copyright 2013 TRENDnet. All Rights Reserved.

Wired LAN MAC Address Filters

Advanced > Filter
Every network device has a unique, 12-digit MAC (Media Access Control) address. Using
MAC filters, you can allow or deny specific computers and other devices from using this
router's wired network.
1. Log into your router management page (see
on page 26).
2. Click on Advanced, click on Filter.
3. Review the MAC Filter options. Click Apply to save settings.
• Filter Mode: Select the mode applied to t listed MAC addresses.
o Allow computers/devices with MAC addresses listed below to access the local
network, web management, and the Internet.
o Deny computers/devices with MAC addresses listed below to access the local
network, web management, and the Internet
Note: MAC filter can be configured to allow access to the listed MAC address and
deny all others unlisted or vice versa. The recommended function is to choose to
only allow access to the MAC addresses listed and deny all others unlisted because it
TEW-812DRU
"Access your router management page"
25