RIGHT REAR
(10)
(8) lug
(9) slot
(10) brake panel
Installation
1.
Reverse the removal procedure. Make sure
the lug ( ) on the swingarm is located in the
8
slot ( ) in the brake panel ( ). Check that
9
the chain adjusters are installed properly.
2.
Adjust the drive chain (page
3.
Torque the rear axle nut to:
35 lbf·ft (46 N·m , 4.8 kgf·m)
(8)
4.
Adjust the rear brake (page
5.
Apply the rear brake, release it, then spin the
wheel and check that it rotates freely. Repeat
this procedure several times.
(9)
If a torque wrench was not used to install the
wheel, see your dealer as soon as possible to
verify proper assembly. Improper assembly
may lead to loss of braking capacity.
Wheels
10
104
).
88
).
95
Servicing Your Honda