Radio Operation; Presetting Stations - Durabrand CD-915 Operating Instructions Manual

RADIO OPERATION

1. Slide the CD/RADIO FUNCTION switch (on
the bottom of the set) to RADIO position.
2. Press the AM/FM BAND button to select the
desired wave band.
3. Tune to desired station by pressing the
SKI P/TU NING but tons . Ea ch t i m e the
button is pressed, the frequency changes.
4. To search for a station quickly (automatic tuning), keep the SKIP/TUNING
buttons pressed until the frequency starts to change rapidly. After tuning into a
strong station, the search stops.
5. If you tune into an FM stereo station, "
6. Adjust the VOLUME control to your listening preference.
7. If you prefer more bass, slide the BASS BOOST switch to ON position.
8. To turn off the radio, slide the CD/RADIO FUNCTION switch to CD position.

Presetting Stations

UP TO 5 AM AND 5 FM STATIONS CAN BE STORED INTO THE PRESET MEMORIES.
(THEY WILL REMAIN IN MEMORY AS LONG AS THE BATTERIES ARE INSTALLED, OR
AC POWER CORD IS CONNECTED.)
1. Slide the CD/RADIO FUNCTION switch to RADIO position.
2. Press the AM/FM BAND button to select AM or FM band, and
press the SKIP/TUNING buttons to select a station.
3. Press the radio MEMORY button, "
M
4. While the " " is blinking, press one of the radio PRESET
buttons repeatedly to select one of 5 memory locations
(1-5) you want to store, press MEMORY button to confirm.
NOTE: Steps 3-4 should be done quickly.
5. Repeat the above steps 2 to 4 to store other 4 stations into memory.
6. Each memory location can store 2 stations, one for AM, the other for FM.
NOTE: Before you disconnect the power (AC and Battery) of the set, make sure
the CD/RADIO FUNCTION switch is at the CD position, then you have
approximately 30 seconds to re-connect the power. Otherwise, the memories
may be lost and need to be re-programmed.
Listening to Preset Stations
1. Slide the CD/RADIO FUNCTION switch to RADIO position.
2. Press the AM/FM BAND button to select the band you want (AM or FM).
3. Press the PRESET buttons to select the stations stored. You will receive the station
you stored into that preset memory location.
4. To shut off the radio, slide the CD/RADIO FUNCTION switch to CD position.
" will show in the display.
FM STEREO
M " will flash in the display. .
(after you programmed them)
9
IB-CD915(CDR25J-60K8)-WM-E-042004
TUNING UP &
DOWN BUTTONS
AM/FM BAND
BUTTON
VOLUME
CONTROL