Documentation Errata - HP NetServer AA 4000 Release Note

• Do not install any device drivers on the CEs that would replace or disable Endurance
drivers, such as:
- Remote control applications that replace Endurance video drivers with their own
video drivers.
- Video display drivers other than the Endurance Video Redirector (MtcVidR.sys).
• Debug tools that use drivers or have application code tied to hardware performance
counters may cause the server to hang or crash. Generally, by following these guidelines
you can avoid problems associated with debug tools:
- Do not run user-level debug tools such as WinDbg and Softice on the CEs.
- Do not use kernel mode (remote) debugging tools because they are not supported on
the CEs.
- Do not run development tools such as VTUNE (a performance application) on the
CEs.

Documentation Errata

The following information was incomplete or incorrect in the Release 4.0 manuals.
• In the HP Netserver AA Solution Installation
you to rename all network adapters to correspond to their function in the Endurance
server. This section indicates you should rename the IL adapter, the Redirected Ethernet
adapters, the IOP Ethernet adapter, and the Virtual Network adapter.
The table should include a note that indicates the Virtual Network is not installed at this
point in the installation process. However, after the Virtual Network is installed, you
should rename the Virtual Network adapters as described.
• In the HP Netserver AA Solution Installation
cell that describes the disk partition where you should install Windows for the IOP
neglects to state that you must install Windows on the C: drive on the first physical disk
on the IOPs. The IOP boot disk must be the C: drive.
Endurance Release Notes for Release 4.0 Service Pack 1
Guide, on page 3-10, the manual instructs
Guide, on page 3-5, under Step 2, the table
19