Problem Solver - GE JE1468L Use And Care & Cooking Manual

First unplug the oven. Then remove lamp
compartment cover by removing screw which
holds cover in place. Cover is located on the
back of the outer case.
Replace with 30-watt appliance bulb. (It is available
in drug and hardware stores.) Replace compartment
cover. Plug in the oven.
PROBLEM
OVEN WWL NOT
COME ON
CONTROL PANEL
LIGHTED, YET OVEN
WILL NOT START
ON DISPLAY
"Error" APPEARS
ON DISPLAY
Steam or vapor escaping from around the door.
Light reflection around door or outer case.
Dimming oven light and change in blower sound
may occur while operating at power levels other
than high.
If you need more help... call, toll free: GE Answer Center"/ 800.626.2000/ consumer information service
38
OVEN LAMP ~PLACEMENT
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
A fuse in your home may be blown or the circuit breaker tripped. Replace fuse or
reset circuit breaker.
Unplug your microwave oven, then plug it back in.
Make sure 3-prong plug on oven is fully inserted into wall receptacle.
Door not securely closed.
START pad must be touched after entering cooking selection.
Another selection entered already in oven and CLEAWOFF pad not touched to
cancel it.
Make sure you have entered cooking time after touching TIME COOK I & II pad.
START pad.
Make sure you have entered a temperature tier touching TEMP COOK & HOLD pad.
Make sure you have entered a code number after touching A~O ROAST or AUTO
COOK pad.
Probe has been forgotten or not seated properly in oven wall when using Temp
Cook & Hold or Auto Roast functions.
During Auto Cook, Auto Reheat or Popcorn program, the door was opened before
steam could be detected, or steam was not detected in maximum time.
No steam was detected by sensor within 4 minutes and 10 seconds after start of
Popcorn program.
All these things are normal with your microwave oven:
/
: ; ::::.,...
I
Dull thumping sound while oven is operating.
Some TV-Radio interference might be noticed
the interference caused by other small appliances
and does not indicate a problem with your oven.
I