Configure Software Delivery Repository Access; Installing Software From Hp Software Delivery Repository - HP BL860c User Manual

Uninstall IFIL
3. Enter an option from the menu and press Enter.
NOTE:
Integrity servers with a SmartArray controller configured with more than one logical drive.
To avoid creating this adverse condition, the installer will not install the HP ACU-CLI
(hpacucli) product on these servers and this option is not displayed in the product
installation menu. Further, if hpacucli is detected on the system, it is uninstalled by the
installer.
4. After the installation is complete, you must start the appropriate framework to access any
providers, execute one of the following:
WBEM Providers (OpenPegasus)
on RHEL or SLES 10:
SMX WBEM Providers (SFCB) on
SLES 11:

Configure Software Delivery Repository Access

The HP Insight Foundation Suite for Integrity Linux provides another delivery method using
the Software Delivery Repository (SDR). This service is offered for both HP internal and external
users. To use this delivery method, perform the following:
Select the Configure Software Delivery Repository Access item from the installer script menu
list.
This delivers the relevant repository access configuration for the user-specific distribution,
version, architecture, and product combination. Next, then user can use the default system tools
(such as yum or zypper) to query, install, and remove packages from the system based on the
repository's contents.
NOTE:
This function not supported by RHEL4

Installing Software from HP Software Delivery Repository

The software included in the HP Support Pack can also be installed through the HP SDR Software
Delivery Repository (SDR) which can be found at:
http://downloads.linux.hp.com/SDR
Before using SDR to install or update the IFIL software on your system, verify your systems
could access the repository.
There is a known compatibility issue with HP ACU-CLI and RHEL5U1 on HP
installer automatically exits after all products are
updated or installed.
This option is displayed only when HP Management
Base is installed on the system.
To remove the IFIL product, including HP
Management Base, enter the appropriate option
number and press Enter. The installer returns to the
menu after the entire IFIL product is removed.
# /etc/init.d/tog-pegasus start
# /etc/init.d/sfcb start
Configure Software Delivery Repository Access 49