Trill Enable - HP 6125XLG Command Reference Manual

Default
The DRB priority of a TRILL port is 64.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
priority: Specifies the DRB priority for a TRILL port. The priority value is in the range of 0 to 127. A higher
priority value indicates a higher priority.
Usage guidelines
On a broadcast network, TRILL must elect a DRB. An RB with a higher DRB priority is preferred. When two
RBs have the same DRB priority, the RB with a higher MAC address takes precedence.
Configuration in Ethernet interface view takes effect on only the current port. Configuration in aggregate
interface view takes effect on the current interface and its member ports. Configuration on the member
port of an aggregate interface takes effect after the member port leaves the aggregation group.
Examples
# Set the DRB priority of TRILL port FortyGigE 1/1/1 to 2.
<Sysname> system-view
[Sysname] interface fortygige 1/1/1
[Sysname-FortyGigE1/1/1] trill drb-priority 2

trill enable

Use trill enable to enable TRILL on a port.
Use undo trill enable to disable TRILL on a port.
Syntax
trill enable
undo trill enable
Default
TRILL is disabled on a port.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Usage guidelines
To enable TRILL on a port, first enable TRILL globally.
Enable or disable TRILL on all ports in a VLAN, so that the ports in a VLAN have the same TRILL status
(enabled or disabled).
Do not enable TRILL and EVB on a port. The allowed VLAN list of a TRILL-enabled port cannot overlap
with that of an EVB-enabled port. For more information about EVB, see EVB Configuration Guide.
24