Electralog 20" Compact Owner's Manual page 10

Operation
integrated on/off
!
NOTE: Ensure that the fire-
place 3 position switch is set to
the remote control setting (up
position).
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out
from between the remote cas-
ing and battery cover (Figure 3).
Remote Control Initialization/
Reprogramming
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
re-initialize the remote control and
the remote control receiver in the
fireplace:
1. Place the
(Figure 2A) in the Off (" O ")
position.
2. Wait a minimum of five sec-
onds and then place the
3-Position Switch
mote Control (" II ") position.
3. Within 10 seconds of chang-
ing the switch position, press
the ON button located on the
remote control (Figure 2).
10
remote control.
off.
3-position switch
in the Re-
This will synchronize the remote
control and the fireplace receiver.
!
NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.
Battery Replacement
(Figure 3)
To replace the battery:
1. Slide battery cover open on
the remote control.
2. Correctly install one 12 Volt
(A23) battery in the battery
holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
www.dimplex.com