Setting Up Your Remote Control - Radio Shack 2-in-1 Remote Control Owner's Manual

Note: Do not place objects on top of the remote control
after you have installed the batteries. Doing so might de-
press keys for an extended period of time and reduce
the battery life.
SETTING UP YOUR REMOTE
CONTROL
You can use the remote control's device keys to control
the following types of devices:
– TVs
TV
– Cable converters
CBL
Your remote control is preset to an RCA TV (compatible
with code 0047) and a Jerrold cable converter (compati-
ble with code 0003). Not all RCA TVs and Jerrold cable
converters will work with the preset codes. Some will re-
quire the other codes listed in Manufacturer's Codes.
Follow these steps to control other brand devices or to
use a different RCA or Jerrold code.
1. Refer to "Manufacturers' Codes" on Page 12 and
write down the codes for the brand of device you
want to program on the supplied label.
Note: Some manufacturers might have several
codes listed. Try each until you find the right one. If
you cannot find the correct code, try performing a
manual search (see "Manual Code Search" on
Page 10).
2. Turn on your TV (or cable converter).
3. Press (or ).
TV CBL
4. Hold down until the red light blinks twice, then
P
enter the 4-digit manufacturer's code for the desired
device. When the red light blinks twice, the remote
control has accepted the code.
For example, to set up the remote control of a Pana-
sonic TV (manufacturer's code 0051), press
hold down until the red light blinks twice, then
P
press .
0 0 5 1
6
Preparation
,
TV