Oki C911dn Material Safety Data Sheet page 15

5. Fire-fighting measures
Extinguishing Media:
Suitable Extinguishing
Media
Unsuitable Extinguishing
Media
Special Hazards
Hazardous Combustion
Products
Advice for Fire-fighters
6. Accidental release measures
Personal Precautions,
Protective Equipment and
Emergency Procedures
Environmental Precautions
Methods and Material for
Containment and Cleaning
Up
Reference to Other Sections
7. Handling and storage
Precautions for Safe
Handling
Conditions for Safe
Storage, Including Any
Incompatibilities
Specific End Uses
8. Exposure controls/personal protection
Control Parameters:
Product
toner Total dust: 15mg/m3
Respirable fraction: 5mg/
m3
Ingredient(s)
Amorphous silica 20mppcf* or 80/%Sio2 mg/
m3 (* million particles per
cubic foot)
Titanium dioxide Total dust: 15mg/m3
: Carbon dioxide, water, form, dry chemical.
None.
:
: It may form explosive dust-air mixtures when finely dispersed in air.
Toner, like most organic powders, is capable of creating a dust explosion when particles are
:
dispersed. Carbon monoxide and carbon dioxide are hazardous resulting gases.
: Wear gloves, glasses and a mask if necessary.
: Avoid dust formation. Do not breathe dust.
Wear personal protective equipment as described in Section 8.
:: Do not discharge into drains.
Eliminate source of ignition and flammables. Vacuum or sweep the material into a sealed container.
If a vacuum cleaner is used, it must be dust explosion-proof. Dispose of the material in accordance
with Federal/state/local requirements.
: Refer to section 13.
: Keep out of reach of children.
Avoid dust formation. Handle in adequately ventilated areas.
Do not breathe dust. Do not get in eyes or on skin.
Keep away from excessive heat and sources of ignition such as sparks and open flames.
Ensure all the equipment is electrically earthed/grounded before beginning operation.
: Keep out of reach of children.
Keep container closed and store at room temperature.
Keep away from excessive heat and sources of ignition.
Do not store with strong oxidizers.
: This product is a toner used in printers/copiers.
USA OSHA PEL ACGIH TLV
Inhalable particulate:
10mg/m3 Respirable
particulate: 3mg.m3
USA OSHA PEL ACGIH TLV
Not listed
10mg/m3
EU OEL
Not established
EU OEL
Not established
Not established
15 - English
DFG MAK
Inhalable fraction: 4mg/m3
Respirable fraction: 1.5mg/
m3
DFG MAK
Inhalable fraction: 4mg/m3
Not established