Table of Contents
Advertisement
Back to Contents Page
Display Assembly
Dell™ Inspiron™ 6400/E1505 Service Manual
Removing the Display Assembly
Replacing the Display Assembly
Display Bezel
Display Panel
Display Latch
Removing the Display Assembly
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
computer.
1. Follow the instructions in
Before Working Inside Your
2. Remove the hinge cover (see
3. Remove the keyboard (see Keyboard).
4. Remove the two M2.5 x 8-mm screws from the bottom of the display.
1
M2.5 x 8-mm screws (2)
5. Remove the two screw covers from the back of the computer; then, remove the two M2.5 x 8-mm screws from the back of the computer.
1
M2.5 x 8-mm screws (2)
6. Remove the two M2.5 x 5-mm screws from the top side of the computer.
7. Disconnect the antenna cables from the Mini-Card.
8. Loosen the captive grounding-wire screw.
9. Disconnect the display cable, using the pull-tab.
10. Dislodge the display cable from the display cable channel.
Computer.
Removing the Hinge
Cover).
Before Working Inside Your
Computer) before working inside the
Hide quick links:
Advertisement
Table of Contents
