Error Messages - QMS Magicolor 2 plus Manual

Press this
key...
Select
The following error messages may appear while you are using the Disk Operations
menu:
Message
FORMAT FAILED
WRITE ERROR
Note: While you're making changes in the configuration menu, you may also want to
»
turn on the printer's page recovery option. (Choose On in the Administration/Engine/
Page Recovery menu.) Page recovery allows the printer to automatically track and
reprint jammed pages so you don't have to resend jobs after clearing a jam.
1 Use the Administration/Memory/Manual Config/K Mem Disc Cache menu to
increase the disk cache size to 1256 KB.
2 Turn the printer off and then on again.
3 Print a status page to check that the Disk Cache size is increased. (Notice
that VM remaining memory is also increased.)
to...
Begin the formatting process. While the system
reboots, the device is being formatted.
Notify you when the formatting process is
complete. The printer then powers up, and a
startup page prints (if enabled).
Meaning
The device cannot be used.
The device encountered a
write error, or there is no
room for the data on the
device or in RAM.
and the message window
reads...
FORMATTING...
FORMAT COMPLETE
Action
Press the Menu key to remove the
message, and contact your local
vendor.
Press the Menu key to remove the
message, and restart the operation
from the beginning.