Refrigerator Doors - Samsung RF62QEPN User Manual

Required Tools (Not provided)
Phillips Head Flat Head Driver(-)
Driver(+)
Hex Wrench Hex wrench
(Ø5mm) (5/32 inch)
(for Mid hinge) (for Mid hinge
shaft)
disassembling the fridge door
Be careful not to drop and scratch the fridge door while removing the fridge door!
WARNING
Top Table
1. Remove the 3 screws
holding down the top table
and remove it.
4. Remove the screw that
holds the ground wire with
a philips screwdriver(+).
REMOvING ThE

REFRIGERATOR dOORS

Some installations require door/drawer removal to
transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed.
Socket Wrench
Before removing the door/drawer make sure you
(10mm) (for bolts)
read following items.
CAUTION
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
2. Disconnect electric wire on
the top of the refrigerator.
5. Separate the hinge from
the electric wire and
ground wire as shown
above.
Disconnect power to the Refrigerator before
removing the door or drawer.
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
3. Remove the 3 hex bolts
that hold the hinge on the
top of the refrigerator with
the 10mm socket wrench.
6. Lift the door straight up to
remove. Be careful not to
drop and scratch the doors
while removing them.
Socket wrench
setting up _09 setting up _09