During The Wash Cycle; On The Utensils - Siemens SN26T592GB Operating Instructions Manual

– Water is left in the appliance at the
end of the programme.
– ( : ) Waste water hose is blocked
or kinked.
Filters blocked.
– ( : ) Waste water pump blocked,
cover on the waste water pump is
not locked in position
(see Maintenance and care).
– Filters blocked.
– The programme has not yet ended.
Wait until programme ends (digital
display indicates :
implement the "Reset" function.
Refill indicator for salt H and/or rinse-
aid P is not lit.
– Refill indicator/s switched off.
– Adequate salt/rinse-aid available.
Refill indicator for special salt H is lit.
– No salt.
Refill with special salt.
– Sensor does not detect salt tablets.
Use different special salt.

... during the wash cycle

Unusual foam formation.
– Handwash liquid in the rinse aid
dispenser.
Spilled rinse aid causes excessive
frothing, therefore please remove with
a cloth.
Appliance stops during the wash cycle.
– Power supply interrupted.
– Water supply interrupted.
Filling valves making striking noises
– Caused by the installation of the water
line and has no effect on the function
of the machine. Remedial action is not
possible.
Knocking/rattling noise during rinsing
– Spray arm is striking utensils.
– Utensils not arranged correctly.

... on the utensils

Food residue on the utensils.
– Utensils placed too closely together,
– Too little detergent.
– Rinse programme too weak.
– Spray arm rotation obstructed.
– Spray arm nozzles blocked.
– Filters blocked.
– Filters incorrectly inserted.
– Waste water pump blocked.
– Top basket on right and left not set to
) or
Tea or lipstick residue is not completely
removed.
– The detergent has an inadequate
– Too low rinsing temperature.
– Too little/unsuitable detergent.
White stains on the utensils/glasses
remain milky.
If phosphate-free detergents are used with
hard tap water, white deposits may be
deposited more easily on utensils and
the container walls.
– Too little/unsuitable detergent.
– Too weak programme selected.
– No/too little rinse aid.
– No/too little special salt.
– Water softening system set to the
– Salt dispenser lock not fastened.
Contact the detergent manufacturer,
in particular if:
– the utensils are very wet at the end of
– limescale forms.
utensils basket overfilled.
same height.
bleaching effect.
wrong value.
the programme.
en
23