4.
Create a virtual Ethernet port profile with an IP access list.
This example creates a simple IP access list that denies IP traffic from virtual machine 20.20.20.22 to
20.20.20.20 and applies this access list to a vEth port profile.
5.
Create an Ethernet port profile.
This example creates an Ethernet port profile that uses vPC host mode for redundancy. Typically, all Ethernet
port profiles are configured as trunk ports.
6.
Create an uplink network.
The network uplink command is new in the Cisco Nexus 1000V Switch for Microsoft Hyper-V. Each uplink
network configured on the VSM is available as a uplink port profile to the Microsoft SCVMM administrator. The
example here creates an uplink network that uses the Ethernet profile UplinkProfile and allows the network
segment pools: DMZ-SFO and DMZ-NY. The uplink network defines the network policy applied to switch
uplink interfaces and the VLANs allowed on them.
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 48 of 48