Element Hot Light Troubleshooting
Each element's hot light limiter switch and its wiring can be tested without removing the cooktop from its
installation. This test will aid the service technician in determining if the element should be replaced. This test
assumes the elements heat properly.
All circuits below element's glass top temperature of 150°F (66°C) should test open. If circuit tests 0
resistance, replace element.
All circuits above element's glass top temperature of 150°F (66°C) should test 0 resistance. If open, check
wiring and replace element, if necessary. Operate element, if necessary, then disconnect power before
testing cooktop.
Model PP 945
Left Rear Element*
Left Front Element*
Right Front Element*
Right Rear Element*
* Requires opening the drop box.
Test Location
RPSM J2 to J21-3
RPSM L1 to J21-2
RPSM L1 to J21-4
RPSM J2 to J21-1
– 22 –
Model PP 975
Left Rear Element*
Left Front Element*
Center Element*
Right Front Element*
Right Rear Element*
Test Location
RPSM L1 to J21-1
RPSM L1 to J21-2
RPSM L1 to J21-4
RPSM L1 to J21-3
RPSM L1 to J21-5