Learning About The Printer; Linking And Unlinking Trays; Understanding The Colors Of The Sleep Button And Indicator Lights - Lexmark MS610dn Quick Reference

Supported flash drives and file types
Flash drive
Many flash drives are tested and approved for use with
the printer. For more information, contact the place
where you purchased the printer.
Notes:
• Hi‑speed USB flash drives must support the
full‑speed standard. Low-speed USB devices are
not supported.
• USB flash drives must support the File Allocation
Table (FAT) system. Devices formatted with New
Technology File System (NTFS) or any other file
system are not supported.
Canceling a print job from the printer control
panel
From the printer control panel, press >

Linking and unlinking trays

1
Open a Web browser, and then type the printer IP address in the
address field.
Notes:
•
View the printer IP address on the printer control panel in
the TCP/IP section under the Network/Ports menu. The IP
address appears as four sets of numbers separated by
periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to
load the Web page correctly.
2
Click Settings > Paper Menu.
3
Change the paper size and type settings for the trays you are linking.
• To link trays, make sure the paper size and type for the tray
match that of the other tray.
• To unlink trays, make sure the paper size or type for the tray
does not match that of the other tray.
4
Click Submit.
Note: You can also change the paper size and type settings using the
printer control panel. For more information, see
size and type" on page
File type
Warning—Potential Damage: Paper loaded in the tray should match
Documents:
the paper type name assigned in the printer. The temperature of the
• .pdf
fuser varies according to the specified paper type. Printing issues
• .xps
may occur if settings are not properly configured.
Images:
• .dcx
• .gif
Using the 4.3-inch display printer
•
.JPEG
model
or .jpg
•
.bmp
• .pcx
• .TIFF

Learning about the printer

or .tif
•
.png
Using the printer control panel
.
7
Use the
1 Display
2 Home button
3 Keypad
"Setting the paper
1.
2 3
1 4
5
6
To
• View the printer status and messages.
• Set up and operate the printer.
Go to the home screen.
Enter numbers, letters, or symbols.
3
Use the To
4 Sleep button Enable Sleep mode or Hibernate mode.
The following actions wake the printer from
Sleep mode:
•
Touching the screen
• Pressing any hard button
• Opening a tray or the front door
• Sending a print job from the computer
•
Performing a power‑on reset using the main
power switch
• Attaching a device to the USB port
5 Stop or cancel Stop all printer activity.
button
6 Indicator light Check the status of the printer.
7 USB port Connect a flash drive to the printer.
Note: Only the front USB port supports flash
drives.
Understanding the colors of the Sleep button
and indicator lights
The colors of the Sleep button and indicator lights on the printer control
panel signify a certain printer status or condition.
Indicator light Printer status
Off The printer is off or in Hibernate mode.
Blinking green The printer is warming up, processing data,
or printing.
Solid green The printer is on, but idle.
Blinking red The printer requires user intervention.
Sleep button light Printer status
Off The printer is off, idle or in Ready state.
Solid amber The printer is in Sleep mode.
Blinking amber The printer is entering or waking from
Hibernate mode.
Blinking amber for 0.1 The printer is in Hibernate mode.
second, then goes
completely off for 1.9
seconds in a slow, pulsing
pattern