Basic Engine - MULTIQUIP SP118 Operation Manual

The engine (Figure 4) must be checked for proper
lubrication and filled with fuel prior to operation. Refer to
the manufacturers engine manual for instructions & details
of operation and servicing.
1. Fuel Filler Cap — Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely. Do noT over fill.
Danger
Adding fuel to the tank should be done
only when the engine is stopped and has
had an opportunity to cool down. In the
event of a fuel spill, Do noT attempt to
start the engine until the fuel residue has
been completely wiped up, and the area surrounding
the engine is dry.
2. Throttle lever — Used to adjust engine RPM speed
(lever advanced forward Slow, lever back toward
operator FaST).
3. engine on/oFF Switch —on position permits engine
starting, oFF position stops engine operations.
4. recoil Starter (pull rope) — Manual-starting method.
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
page 20 — Sp118 pavemenT Saw • operaTion manual — rev. #1 (05/03/12)
Figure 4. Engine Components
5. Fuel valve lever — open to let fuel flow, CloSe to
6. Choke lever — Used in the starting of a cold engine,
7. air Cleaner — Prevents dirt and other debris from
Operating the engine without an air filter, with a
damaged air filter, or a filter in need of replacement
will allow dirt to enter the engine, causing rapid engine
wear.
8. Spark plug — Provides spark to the ignition system.
9. muffler — Used to reduce noise and emissions.
Engine components can generate extreme heat. To
prevent burns, Do noT touch these areas while the
engine is running or immediately after operating. never
operate the engine with the muffler removed.
10. Fuel Tank — Holds unleaded gasoline. For additional
stop the flow of fuel.
or in cold weather conditions. The choke enriches the
fuel mixture.
entering the fuel system. Remove wing-nut on top of
air filter cannister to gain access to filter element.
NOTICE
Clean spark plug once a month.
warning
information refer to engine owner's manual.

baSic enGine