Ii-5. Reset To Factory Default Settings - Edimax BR-6228nS V2 User Manual

II‐4. WPS Setup
If your wireless device supports WPS (Wi‐Fi Protected Setup) then you can use this
method to connect to the BR‐6228nS V2/nC V2's Wi‐Fi network.
1.
Press the WPS button on the BR‐6228nS V2/nC V2
for 2 – 5 seconds to activate WPS. The WLAN LED
will flash to indicate that WPS is active.
2.
Within two minutes, press the WPS button on the
wireless device/client to activate its WPS.
3.
The devices will establish a connection. Repeat for additional wireless devices.
Please check the instructions for your wireless device for how long
you need to hold down its WPS button to activate WPS.
II‐5. Reset to Factory Default Settings
If you experience problems with your BR‐6228nS V2/nC V2, you can reset the
device back to its factory settings. This resets all settings back to default.
1.
Press and hold the WPS/Reset button found on the back panel for at least
10 seconds, until the power LED begins to flash.
2.
Release the button when the power LED is flashing.
3.
Wait for the BR‐6228nS V2/nC V2 to restart. The BR‐6228nS V2/nC V2 is
ready for setup when the power LED displays on.
22